summaryrefslogtreecommitdiff
path: root/doc/rfc/rfc516.txt
diff options
context:
space:
mode:
Diffstat (limited to 'doc/rfc/rfc516.txt')
-rw-r--r--doc/rfc/rfc516.txt115
1 files changed, 115 insertions, 0 deletions
diff --git a/doc/rfc/rfc516.txt b/doc/rfc/rfc516.txt
new file mode 100644
index 0000000..336081d
--- /dev/null
+++ b/doc/rfc/rfc516.txt
@@ -0,0 +1,115 @@
+
+
+
+
+
+
+Network Working Group Jonathan B. Postel
+RFC # 516 UCLA-NMC
+NIC # 16683 May 18, 1973
+
+
+ LOST MESSAGE DETECTION
+
+I have three suggestions for detecting the loss of messages by the
+communications subsystem. The first of these is perhaps the more
+powerful and simpler to implement since it uses no new concepts and has
+the power to retransmit the message detected as lost.
+
+The first scheme:
+
+ If upon sending a message the host saved a copy of that message and
+ waited until either:
+
+ a RFNM was returned, in which case everything is ok and the next
+ message is processed.
+
+ a INCOMPLETE TRANSMISSION is returned, in which case the copy of
+ the message is retransmitted (this could be a loop so put a
+ finite upper bound on the number of times to retransmit the same
+ message).
+
+ a DESTINATION DEAD is returned, in which case mark the
+ destination down and require the exchange of reset commands
+ before further communication is allowed.
+
+ something else is received indicating an error in the network or
+ local IMP, in which case at least log the error, and probably
+ close the conversation.
+
+ Following the above procedures either on a per host basis or a per
+ link basis should prevent a lost message problem from
+ developing.
+
+The second scheme:
+
+ If on a per host basis, message numbers are included in the host to
+ host header of messages,, and messages are delivered in order (this
+ is currently the case in the network, except for priority messages
+ so this proposal requires that each host either send everything as
+ priority or nothing as priority) then each receiving host can detect
+ a missing message by comparing the message number of the received
+ message with the previously received message.
+
+ On exchanging resets the sequence numbers between that pair of
+
+
+
+Postel [Page 1]
+
+RFC 516 LOST MESSAGE DETECTION May 1973
+
+
+ hosts is set to zero.
+
+ Each time a message is sent the current send message number is
+ entered into a field in the message header, and the current send
+ message number is incremented (modulo N, say N=256)
+
+ Each time a message is received the message number from the
+ message is compared to the current receive message number and:
+
+ if the received message is the expected one then the message
+ is acceptable and current receive message number is
+ incremented (modulo N);
+
+ if the received message is not the expected one then a
+ message has been lost.
+
+ What to do when a missing message is detected, not clear, but at
+ least can be logged and reported to the network control center. A
+ missing message may not be fatal to an interactive conversation, but
+ it is critical in a file transfer, thus I suggest that missing
+ messages which are not recovered be cause to close the conversation.
+
+The third scheme:
+
+ Host to host acknowledgements could be required. Such an
+ acknowledgement scheme could be implemented similarly to the IMP to
+ IMP scheme. This is a serious change to the current protocols so I
+ will not elaborate on it here, feeling that deeper study will be
+ necessary to fully specify a reasonable host to host acknowledgement
+ strategy.
+
+
+Of these three suggestions the first is the most immediately practical
+and implementable; in fact several hosts all ready do this. These
+schemes also are non-conflicting, they could be implemented and used
+simultaneously.
+
+
+
+
+
+
+
+
+ [ This RFC was put into machine readable form for entry ]
+ [ into the online RFC archives by Alex McKenzie with ]
+ [ support from GTE, formerly BBN Corp. 9/99 ]
+
+
+
+
+Postel [Page 2]
+