1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
|
Network Working Group S. Hardcastle-Kille
Request for Comments: 1328 University College London
May 1992
X.400 1988 to 1984 downgrading
Status of this Memo
This RFC specifies an IAB standards track protocol for the Internet
community, and requests discussion and suggestions for improvements.
Please refer to the current edition of the "IAB Official Protocol
Standards" for the standardization state and status of this protocol.
Distribution of this memo is unlimited.
Abstract
This document considers issues of downgrading from X.400(1988) to
X.400(1984) [MHS88a, MHS84]. Annexe B of X.419 specifies some
downgrading rules [MHS88b], but these are not sufficient for
provision of service in an environment containing both 1984 and 1988
components. This document defines a number of extensions to this
annexe.
This specification is not tutorial. COSINE Study 8.2 by J.A.I.
Craigie gives a useful overview [Cra88].
1. The need to Downgrade
It is expected that X.400(1988) systems will be extensively deployed,
whilst there is still substantial use of X.400(1984). If 1988
features are to be used, it it important for there to be a clear
approach to downgrading. This document specifies an approach to
downgrading for the Internet and COSINE communities. As 1988 is a
strict superset of 1984, the mapping is a one-way problem.
2. Avoiding Downgrading
Perhaps the most important consideration is to configure systems so
as to minimise the need for downgrading. Use of 1984 systems to
interconnect 1988 systems should be strenuously avoided.
In practice, many of the downgrading issues will be avoided. When a
1988 originator sends to a 1984 recipient, 1988 specific features
will not be used as they will not work! For distribution lists with
1984 and 1988 recipients, messages will tend to be "lowest common
denominator".
Hardcastle-Kille [Page 1]
^L
RFC 1328 X.400 1988 to 1984 downgrading May 1992
3. Addressing
In general there is a problem with O/R addresses which use 88
specific features. The X.419 downgrade approach will mean that
addresses using these features cannot be specified from 84 systems.
Worse, a message originating from such an address cannot be
transferred into X.400(1984). This is unacceptable. Two approaches
are defined. The first is a general purpose mechanism, which can be
implemented by the gateway only. The second is a special purpose
mechanism to optimise for a form of X.400(88) address which is
expected to be used frequently (Common Name). The second approach
requires cooperation from all X.400(88) UAs and MTAs which are
involved in these interactions.
3.1 General Approach
The first approach is to use a DDA "X400-88". The DDA value is an
std-or encoding of the address as defined in RFC 1327 [Kil92]. This
will allow source routing through an appropriate gateway. This
solution is general, and does not require co-operation. For example:
88:
PD-ADDRESS=Empire State Building; PRMD=XX; ADMD=ZZ; C=US;
84:
O=MHS-Relay; PRMD=UK.AC; C=GB;
DD.X400-88=/PD-ADDRESS=Empire State Building/PRMD=XX/ADMD=ZZ/C=US/;
The std-or syntax can use IA5 characters not in the printable string
set (typically to handle teletext versions). To enable this to be
handled, the std-or encoded in encapsulated into printable string
using the mappings of Section 3.4 of RFC 1327. Where the generated
address is longer than 128 characters, up to three overflow domain
defined attributes are used: X400-C1; X400-C2; X400-C3.
3.2 Common Name
Where a common name attribute is used, this is downgraded to the
Domain Defined Attribute "Common". For example:
88:
CN=Postmaster; O=A; ADMD=B; C=GB;
84:
DD.Common=Postmaster; O=A; ADMD=B; C=GB;
The downgrade will always happen correctly. However, it will not
always be possible for the gateway to do the reverse mapping.
Hardcastle-Kille [Page 2]
^L
RFC 1328 X.400 1988 to 1984 downgrading May 1992
Therefore, this approach requires that all 1988 MTAs and UAs which
wish to interact with 1984 systems through gateways following this
specification will need to understand the equivalence of these two
forms of address.
4. MTS
Annexe B of X.419 is sufficient, apart from the addressing.
The discard of envelope fields is unfortunate. However, the
criticality mechanism ensures that no information the originator
specifies to be critical is discarded. There is no sensible
alternative. If mapping to a system which support the MOTIS-86 trace
extensions, it is recommended that the internal trace of X.400(88) is
mapped on to this, noting the slight differences in syntax.
5. IPM Downgrading
The IPM service in X.400(1984) is usually provided by content type 2.
In many cases, it will be useful for a gateway to downgrade P2 from
content type 22 to 2. This will clearly need to be made dependent on
the destination, as it is quite possible to carry content type 22
over P1(1984). The decision to make this downgrade will be on the
basis of gateway configuration.
When a gateway downgrades from 22 to 2, the following should be done:
1. Strip any 1988 specific headings (language indication, and
partial message indication).
2. Downgrade all O/R addresses, as described in Section 3.
3. If a directory name is present, there is no method to preserve
the semantics within a 1984 O/R Address. However, it is
possible to pass the information across, so that the information
in the Distinguished Name can be informally displayed to the
end user. This is done by appendend a text representation of
the Distinguished Name to the Free Form Name enclosed in round
brackets. It is recommended that the "User Friendly Name"
syntax is used to represent the Distinguished Name [Kil90]. For
example:
(Steve Hardcastle-Kille, Computer Science,
University College London, GB)
4. The issue of body part downgrade is discussed in Section 6.
Hardcastle-Kille [Page 3]
^L
RFC 1328 X.400 1988 to 1984 downgrading May 1992
5.1 RFC 822 Considerations
A message represented as content type 22 may have originated from RFC
822 [Cro82]. The downgrade for this type of message can be improved.
This is discussed in RFC 1327 [Kil92].
6. Body Part downgrading
The issue of body part downgrade is very much linked up with the
whole issue of body part format conversion. If no explicit
conversion is requested, conversion depends on the MTA knowing the
remote UA's capabilities. The following options are available for
body part conversion in all cases, including this one. It is assumed
that body part conversion is avoided where possible.
1. Downgrade to a standard 1984 body part, without loss of
information
2. Downgrade to a standard 1984 body part, with loss of information
3. Discard the body part, and replace with a (typically IA5 text)
message. For example:
**********************************************
*
* There was a hologram here which could
* not be converted
*
**********************************************
4. Bounce the message
If conversion is prohibited, 4) must be done. If conversion-with-
loss is prohibited, 1) should be done if possible, otherwise 4). In
other cases 2) should be done if possible. If it is not possible,
the choice between 3) and 4) should be a configuration choice. X.419
only recognises 4). 3) Seems to be a useful choice in practice,
particularly where the message contains other body parts. Another
option is available when downgrading:
1. Encapsulate the body part as a Nationally Defined 1984
body part (body part 7).
This should be used when configured for the recipient UA.
Hardcastle-Kille [Page 4]
^L
RFC 1328 X.400 1988 to 1984 downgrading May 1992
References
[Cra88] Craigie, J., "Migration strategy for x.400(84) to
x.400(88)/MOTIS", COSINE Specification Phase 8.2, RARE, 1988.
[Cro82] Crocker, D., "Standard of the Format of ARPA Internet Text
Messages", RFC 822, UDEL, August 1982.
[Kil90] Kille, S., "Using the OSI directory to achieve user friendly
naming", Research Note RN/90/29, Department of Computer
Science, University College London, February 1990.
[Kil92] Kille, S., "Mapping between X.400(1988) / ISO 10021 and RFC
822", RFC 1327, University College London, May 1992.
[MHS84] Recommendations X.400, October 1984. CCITT SG 5/VII, Message
Handling Systems: System Model - Service Elements.
[MHS88a] CCITT recommendations X.400 / ISO 10021, April 1988. CCITT
SG 5/VII / ISO/IEC JTC1, Message Handling: System and
Service Overview.
[MHS88b] CCITT recommendations X.419/ ISO 10021, April 1988.
CCITT SG 5/VII / ISO/IEC JTC1, Message Handling: Protocol
Specifications.
7. Security Considerations
Security issues are not discussed in this memo.
8. Author's Address
Steve Hardcastle-Kille
Department of Computer Science
University College London
Gower Street
WC1E 6BT
England
Phone: +44-71-380-7294
EMail: S.Kille@CS.UCL.AC.UK
Hardcastle-Kille [Page 5]
^L
|
