path: root/doc/rfc/rfc3722.txt

Network Working Group                                           M. Bakke
Request for Comments: 3722                                         Cisco
Category: Standards Track                                     April 2004


              String Profile for Internet Small Computer
                    Systems Interface (iSCSI) Names

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2004).  All Rights Reserved.

Abstract

   This document describes how to prepare internationalized iSCSI names
   to increase the likelihood that name input and comparison work in
   ways that make sense for typical users throughout the world.

   The Internet Small Computer Systems Interface (iSCSI) protocol
   provides a way for hosts to access SCSI devices over an IP network.
   The iSCSI end-points, called initiators and targets, each have a
   globally-unique name that must be transcribable, as well as easily
   compared.

1.  Introduction

   The iSCSI protocol [RFC3720] provides a way for hosts to access SCSI
   [SAM2] devices over an IP network.  The iSCSI end-points, called
   initiators and targets, each have a globally-unique name, defined in
   [RFC3721].

   An iSCSI name is a string of UTF-8 [RFC3629] characters that includes
   a type designator, a naming authority based on domain names, and a
   unique part within the naming authority.  The unique part may be
   generated based on anything the naming authority deems useful, and
   may include user input.

   These names may need to be transcribed (sent between two
   administrators via email, voice, paper, etc), so a case-insensitive
   comparison would be desirable.  However, these names must often be



Bakke                       Standards Track                     [Page 1]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


   compared by initiator and target implementations, most of which are
   done in simple, embedded software.  This makes case-sensitive
   comparison highly desirable for these implementors.

   However, a completely case-sensitive implementation would result in
   identifiers such as "example-name" and "Example-Name" being
   different, which could lead to confusion as these names are
   transcribed.

   The goal, then, is to generate iSCSI names that can be transcribed
   and entered by users, and also compared byte-for-byte, with minimal
   confusion.  To attain these goals, iSCSI names are generalized using
   a normalized character set (converted to lower case or equivalent),
   with no white space allowed, and very limited punctuation.

   For those using only ASCII characters (U+0000 to U+007F), the
   following characters are allowed:

   -  ASCII dash character ('-' = U+002d)
   -  ASCII dot character ('.' = U+002e)
   -  ASCII colon character (':' = U+003a)
   -  ASCII lower-case characters ('a'..'z' = U+0061..U+007a)
   -  ASCII digit characters ('0'..'9' = U+0030..U+0039)

   In addition, any upper-case characters input via a user interface
   MUST be mapped to their lower-case equivalents.

   This document specifies the valid character set for iSCSI names,
   along with the rules for normalizing and generating iSCSI names based
   on user input or other information that contains international
   characters.

   In particular, it defines the following, as required by [RFC3454]:

   -  The intended applicability of the profile: internationalized iSCSI
      names.

   -  The character repertoire that is the input and output to
      stringprep: Unicode 3.2, specified in section 3.

   -  The mappings used: specified in section 4.

   -  The Unicode normalization used: specified in section 5.

   -  The characters that are prohibited as output: specified in section
      6.

   This profile MUST be used with the iSCSI protocol.



Bakke                       Standards Track                     [Page 2]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


2.  Terminology

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

   Examples in this document use the notation for code points and names
   from the Unicode Standard [Unicode3.2] and ISO/IEC 10646 [ISO10646].
   For example, the letter "a" may be represented as either "U+0061" or
   "LATIN SMALL LETTER A".  In the lists of prohibited characters, the
   "U+" is left off to make the lists easier to read.  The comments for
   character ranges are shown in square brackets (such as "[SYMBOLS]")
   and do not come from the standards.

3.  Character Repertoire

   This profile uses Unicode 3.2, as defined in [RFC3454] Appendix A.

4.  Mapping

   This profile specifies mapping using the following tables from
   [RFC3454].  The following mapping tables MUST be used when generating
   iSCSI names from Unicode characters.

      Table B.1
      Table B.2

5.  Normalization

   Unicode normalization form KC MUST be used with this profile, as
   described in [RFC3454].

6.  Prohibited Output

   This profile specifies prohibiting using the following tables from
   [RFC3454].  Characters appearing within these tables MUST NOT be used
   within an iSCSI name.

      Table C.1.1
      Table C.1.2
      Table C.2.1
      Table C.2.2
      Table C.3
      Table C.4
      Table C.5
      Table C.6





Bakke                       Standards Track                     [Page 3]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


      Table C.7
      Table C.8
      Table C.9

   Important note: this profile MUST be used with the iSCSI protocol.
   The iSCSI protocol has additional naming rules that are checked
   outside of this profile.

   In addition, this profile adds the following prohibitions.  The full
   set of prohibited characters are those from the tables above plus
   those listed individually below.

6.1.  Inappropriate Characters from Common Input Mechanisms

   u+3002 is used as if it were u+002e in many domain name input
   mechanisms used by applications, particularly in Asia.  The character
   u+3002 MUST NOT be used in an iSCSI name.

      3002; ideographic full stop

6.2.  Currently-prohibited ASCII characters

   Some of the ASCII characters that are currently prohibited in iSCSI
   names by [RFC3721] are also used in protocol elements such as URIs.
   Some examples are described in [RFC2396] and [RFC2732].  Note that
   there are many other RFCs that define additional URI schemes.

   The other characters in the range U+0000 to U+007F that are not
   currently allowed are prohibited in iSCSI names to reserve them for
   future use in protocol elements.  Note that the dash (U+002D), dot
   (U+002E), and colon (U+003A) are not prohibited.

   The following characters MUST NOT be used in iSCSI names:

      0000-002C; [ASCII CONTROL CHARACTERS and SPACE through ,]
      002F; [ASCII /]
      003B-0040; [ASCII ; through @]
      005B-0060; [ASCII [ through `]
      007B-007F; [ASCII { through DEL]

7.  Bidirectional Characters

   This profile specifies checking bidirectional strings as described in
   [RFC3454] section 6.







Bakke                       Standards Track                     [Page 4]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


8.  Unassigned Code Points in Internationalized Domain Names

   If the processing in [RFC3720] specifies that a list of unassigned
   code points be used, the system uses table A.1 from [RFC3454] as its
   list of unassigned code points.

9.  Security Considerations

   ISO/IEC 10646 has many characters that look similar.  In many cases,
   users of security protocols might do visual matching, such as when
   comparing the names of trusted third parties.  This profile does
   nothing to map similar-looking characters together.

   iSCSI names may be used by an initiator to verify that a target it
   has discovered is the correct one, and by a target to verify that an
   initiator is to be allowed access.  If these names are interpreted
   and compared differently by different iSCSI implementations, an
   initiator could gain access to the wrong target, or could be denied
   access to a legitimate target.

10.  IANA Considerations

   This is a profile of stringprep.  It has been registered in the IANA
   "Stringprep Profiles" registry.  This process is described in the
   IANA Considerations section of [RFC3454].

11.  Summary

   This document describes a stringprep profile to be used with programs
   generating names for iSCSI initiators and targets.

12.  Acknowledgements

   This document was produced as a result of discussions on iSCSI name
   formats with Joe Czap, Jim Hafner, Howard Hall, Jack Harwood, John
   Hufferd, Marjorie Krueger, Lawrence Lamers, Todd Sperry, Joshua
   Tseng, and Kaladhar Voruganti, as well as discussions on the
   normalization of names into identifiers with Paul Hoffman and Marc
   Blanchet.

   Thanks also to Bob Snively for suggesting the use of the nameprep
   process for iSCSI name normalization.

   Most of this document was copied from the stringprep profile for
   Internationalized Domain Names [RFC3491], written by Paul Hoffman and
   Marc Blanchet.





Bakke                       Standards Track                     [Page 5]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


13.  References

13.1.  Normative References

   [RFC2119]    Bradner, S., "Key words for use in RFCs to Indicate
                Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC3454]    Hoffman, P. and M. Blanchet, "Preparation of
                Internationalized Strings ("stringprep")", RFC 3454,
                December 2002.

   [RFC3720]    Satran, J., Meth, K., Sapuntzakis, C. Chadalapaka, M.
                and E. Zeidner, "Internet Small Computer Systems
                Interface (iSCSI)", RFC 3720, April 2004.

13.2.  Informative References

   [RFC2396]    Berners-Lee, T., Fielding, R. and L. Masinter, "Uniform
                Resource Identifiers", RFC 2396, August 1998.

   [RFC2732]    Hinden, R., Carpenter, B. and L. Masinter, "Format for
                Literal IPv6 Addresses in URL's", RFC 2732, December
                1999.

   [RFC3491]    Hoffman, P. and M. Blanchet, "Nameprep: A Stringprep
                Profile for Internationalized Domain Names", RFC 3491,
                March 2003.
   [RFC3629]    Yergeau, F., "UTF-8, a transformation format of ISO
                10646", STD 63, RFC 3629, November 2003.

   [RFC3721]    Bakke, M., Hafner, J., Hufferd, J., Voruganti, K. and M.
                Krueger, "Internet Small Computer Systems Interface
                (iSCSI) Naming and Discovery", RFC 3721, April 2004.

   [SAM2]       ANSI T10.  "SCSI Architectural Model 2", March 2000.

   [Unicode3.2] The Unicode Standard, Version 3.2.0: The Unicode
                Consortium.  The Unicode Standard, Version 3.2.0 is
                defined by The Unicode Standard, Version 3.0 (Reading,
                MA, Addison-Wesley, 2000. ISBN 0-201-61633-5), as
                amended by the Unicode Standard Annex #27: Unicode 3.1
                (http://www.unicode.org/unicode/reports/tr27/) and by
                the Unicode Standard Annex #28: Unicode 3.2
                (http://www.unicode.org/unicode/reports/tr28/).







Bakke                       Standards Track                     [Page 6]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


   [ISO10646]   ISO/IEC 10646-1:2000. International Standard --
                Information technology -- Universal Multiple-Octet Coded
                Character Set (UCS) -- Part 1: Architecture and Basic
                Multilingual Plane.

14.  Author's Address

   Mark Bakke
   Cisco Systems, Inc.
   6450 Wedgwood Road
   Maple Grove, MN
   USA 55311

   Voice: +1 763-398-1000
   EMail: mbakke@cisco.com




































Bakke                       Standards Track                     [Page 7]
^L
RFC 3722             String Profile for iSCSI Names           April 2004


15.  Full Copyright Statement

   Copyright (C) The Internet Society (2004).  This document is subject
   to the rights, licenses and restrictions contained in BCP 78, and
   except as set forth therein, the authors retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.









Bakke                       Standards Track                     [Page 8]
^L