1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
|
Network Working Group C. Perkins
Request for Comments: 4421 University of Glasgow
Updates: 4175 February 2006
Category: Standards Track
RTP Payload Format for Uncompressed Video:
Additional Colour Sampling Modes
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2006).
Abstract
The RFC Payload Format for Uncompressed Video, RFC 4175, defines a
scheme to packetise uncompressed, studio-quality, video streams for
transport using RTP. This memo extends the format to support
additional colour sampling modes.
1. Introduction
The RTP Payload Format for Uncompressed Video [1] defines a scheme to
packetise uncompressed, studio-quality, video streams for transport
using RTP [2]. A range of standard and high-definition video formats
is supported, and parameters are defined so sender and receiver can
negotiate the image size, colour space, pixel depth, and colour
sampling mode.
A limitation of the signalling is that the number of bits per sample
is assumed to be the same for each colour component. For example, it
is possible to signal video using RGB colour sampling with 8 bits for
each of the Red, Green, and Blue components (24 bits per pixel), but
not video using RGB colour sampling with 5 bits each for the Red and
Blue components, but 6 bits for the Green component (16 bits per
pixel). Such video formats can easily be transported by the payload
format, but cannot be signalled using the parameters defined. This
memo extends [1] with additional colour sampling modes, to signal
such video formats.
Perkins Standards Track [Page 1]
^L
RFC 4421 RTP Payload for Uncompressed Video February 2006
2. Conventions Used in this Document
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [3].
3. Payload Format Parameters
This memo defines six new colour sampling modes that MAY be signalled
for use with [1]. The new modes are "RGB+", "RG+B", "R+GB", "BGR+",
"BG+R", and "B+GR". These sampling modes use the same packing order
of samples as do the RGB and BGR colour sampling modes, respectively
(Section 4.3 of [1]), except that an additional bit per sample of
colour depth MUST be used for the component marked by the + symbol.
The mandatory parameter "depth=N" indicates that N bits per sample
are used by the unmarked components, but N+1 bits are used by the
marked component. All other features of the payload format are as
defined in [1].
The primary use of these colour sampling modes is to enable efficient
packing of data into small pixel groups ("pgroups"). The most common
use case is expected to be video with "depth=5", where the additional
bit of colour depth for the marked component enables a single pixel
to fit into two octets without padding. The new colour sampling
modes MAY be used for other depths, however, should that prove
useful.
4. Example
A common uncompressed video format is RGB with 5 bits for the Red and
Blue components and 6 bits for the Green component, for a total of 16
bits per pixel. Using the sampling modes defined in this memo, this
can be signalled in Session Description Protocol (SDP) according to
the following example:
v=0
o=jdoe 2890844526 2890842807 IN IP4 192.0.2.5
s=-
c=IN IP4 192.0.2.6
t=2873397496 2873404696
m=video 51372 RTP/AVP 99
a=rtpmap:99 raw/90000
a=fmtp:99 sampling=RG+B; width=1024; height=768; depth=5;
colorimetry=SMPTE240M
The last line has been wrapped due to formatting constraints of this
memo, and forms one complete line in the SDP file.
Perkins Standards Track [Page 2]
^L
RFC 4421 RTP Payload for Uncompressed Video February 2006
5. Security Considerations
The security considerations of [1] apply. No additional security
considerations are introduced by support for new colour sampling
modes.
6. IANA Considerations
The video/raw media type is extended with six new values for the
"sampling" parameter according to the rules defined in Section 6.2 of
[1]. The new values are "RGB+", "RG+B", "R+GB", "BGR+", "BG+R", and
"B+GR" as described in this memo.
7. Acknowledgements
Thanks to Jeremy Searle and Andrew Lee at Westland Helicopters.
8. Normative References
[1] Gharai, L. and C. Perkins, "RTP Payload Format for Uncompressed
Video", RFC 4175, September 2005.
[2] Schulzrinne, H., Casner, S., Frederick, R., and V. Jacobson,
"RTP: A Transport Protocol for Real-Time Applications", STD 64,
RFC 3550, July 2003.
[3] Bradner, S., "Key words for use in RFCs to Indicate Requirement
Levels", BCP 14, RFC 2119, March 1997.
Author's Address
Colin Perkins
University of Glasgow
Department of Computing Science
17 Lilybank Gardens
Glasgow G12 8QQ
UK
EMail: csp@csperkins.org
Perkins Standards Track [Page 3]
^L
RFC 4421 RTP Payload for Uncompressed Video February 2006
Full Copyright Statement
Copyright (C) The Internet Society (2006).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is provided by the IETF
Administrative Support Activity (IASA).
Perkins Standards Track [Page 4]
^L
|
