1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
|
Network Working Group M. Baker
Request for Comments: 3902 Independent
Category: Informational M. Nottingham
BEA Systems
September 2004
The "application/soap+xml" media type
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2004).
Abstract
This document defines the "application/soap+xml" media type which can
be used to describe SOAP 1.2 messages serialized as XML 1.0.
1. Introduction
SOAP version 1.2 (SOAP) is a lightweight protocol intended for
exchange of structured information between peers in a decentralized,
distributed environment. It defines an extensible messaging
framework that contains a message construct based on XML technologies
that can be exchanged over a variety of underlying protocols.
This specification defines the media type "application/soap+xml"
which can be used to identify SOAP 1.2 message envelopes that have
been serialized with XML 1.0. Such serializations are useful as the
basis of "wire formats" for SOAP 1.2 Protocol Binding Specifications
[W3C.REC-soap12-part1-20030624], or in other situations where an XML
serialization of a SOAP envelope is required.
The "application/soap+xml" media type explicitly identifies SOAP 1.2
message envelopes that have been serialised with XML 1.0; message
envelopes with a different SOAP namespace version or using another
XML serialisation MUST NOT use it.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
Baker & Nottingham Informational [Page 1]
^L
RFC 3902 The "application/soap+xml" media type September 2004
2. Registration
MIME media type name: application
MIME subtype name: soap+xml
Required parameters: none
Optional parameters:
"charset": This parameter has identical semantics to the charset
parameter of the "application/xml" media type as specified in
RFC 3023 [RFC3023].
"action": This optional parameter can be used to specify the URI
that identifies the intent of the message. In SOAP 1.2, it
serves a similar purpose as the SOAPAction HTTP header field
did in SOAP 1.1. Namely, its value identifies the intent of
the message.
The value of the action parameter is an absolute URI-reference
as defined by RFC 2396 [RFC2396], which MUST be non-empty.
SOAP places no restrictions on the specificity of the URI or
that it is resolvable. Although the purpose of the action
parameter is to indicate the intent of the SOAP message there
is no mechanism for automatically computing the value based on
the SOAP envelope. In other words, the value has to be
determined out of band. It is recommended that the same value
be used to identify sets of message types that are logically
connected in some manner, for example part of the same
"service". It is strongly RECOMMENDED that the URI be globally
unique and stable over time.
Use of the action parameter is OPTIONAL. SOAP Receivers MAY
use it as a hint to optimize processing, but SHOULD NOT require
its presence in order to operate.
Encoding considerations: Identical to those of "application/xml" as
described in RFC 3023 [RFC3023], section 3.2, as applied to the
SOAP envelope infoset.
Security considerations: Because SOAP can carry application defined
data whose semantics is independent from that of any MIME wrapper
(or context within which the MIME wrapper is used), one should not
expect to be able to understand the semantics of the SOAP message
based on the semantics of the MIME wrapper alone. Therefore,
whenever using the "application/soap+xml" media type, it is
strongly RECOMMENDED that the security implications of the context
within which the SOAP message is used is fully understood. The
security implications are likely to involve both the specific SOAP
binding to an underlying protocol as well as the application-
Baker & Nottingham Informational [Page 2]
^L
RFC 3902 The "application/soap+xml" media type September 2004
defined semantics of the data carried in the SOAP message (though
one must be careful when doing this, as discussed in SOAP 1.2 Part
1 [W3C.REC-soap12-part1-20030624], section Binding to
Application-Specific Protocols).
Also, see SOAP 1.2 Part 1 [W3C.REC-soap12-part1-20030624], the
entire section Security Considerations.
In addition, as this media type uses the "+xml" convention, it
shares the same security considerations as described in RFC 3023
[RFC3023], section 10.
The action parameter is not a security mechanism, and SHOULD NOT
be used for authentication. If the action parameter is used to
make decisions (e.g., dispatch, filtering), it is RECOMMENDED that
the basis for such decisions should be confirmed by examining the
SOAP Envelope.
Interoperability considerations: There are no known interoperability
issues.
Published specification: SOAP 1.2 Part 1
[W3C.REC-soap12-part1-20030624] and SOAP 1.2 Part 2
[W3C.REC-soap12-part2-20030624].
Applications which use this media type: Various SOAP 1.2 conformant
toolkits use this media type.
Additional information:
File extension: SOAP messages are not required or expected to be
stored as files.
Fragment identifiers: Identical to that of "application/xml" as
described in RFC 3023 [RFC3023], section 5.
Base URI: As specified in RFC 3023 [RFC3023], section 6. Also see
SOAP 1.2 Part 1 [W3C.REC-soap12-part1-20030624], section Use of
URIs in SOAP.
Macintosh File Type code: TEXT
Person and email address to contact for further information:
World Wide Web Consortium <web-human@w3.org>
Intended usage: COMMON
Author/Change controller: The SOAP 1.2 specification set is a work
product of the World Wide Web Consortium's XML Protocol Working
Group. The W3C has change control over these specifications.
3. Security Considerations
See the "Security Considerations" section of the registration
template found in Section 2.
Baker & Nottingham Informational [Page 3]
^L
RFC 3902 The "application/soap+xml" media type September 2004
4. Normative References
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC2396] Berners-Lee, T., Fielding, R., and L. Masinter, "Uniform
Resource Identifiers (URI): Generic Syntax", RFC 2396,
August 1998.
[RFC3023] Murata, M., St.Laurent, S., and D. Kohn, "XML Media
Types", RFC 3023, January 2001.
[W3C.REC-soap12-part1-20030624]
Hadley, M., Mendelsohn, N., Moreau, J., Nielsen, H., and
M. Gudgin, "SOAP Version 1.2 Part 1: Messaging
Framework", W3C REC REC-soap12-part1-20030624, June 2003.
[W3C.REC-soap12-part2-20030624]
Moreau, J., Nielsen, H., Gudgin, M., Hadley, M., and N.
Mendelsohn, "SOAP Version 1.2 Part 2: Adjuncts", W3C REC
REC-soap12-part2-20030624, June 2003.
5. Authors' Addresses
Mark A. Baker
Independent
37 Charles St.
Ottawa, Ontario K1M 1R3
CA
EMail: distobj@acm.org
Mark Nottingham
BEA Systems
235 Montgomery St., Level 15
San Francisco, CA 94010
US
EMail: mnot@pobox.com
Baker & Nottingham Informational [Page 4]
^L
RFC 3902 The "application/soap+xml" media type September 2004
6. Full Copyright Statement
Copyright (C) The Internet Society (2004).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and at www.rfc-editor.org, and except as set
forth therein, the authors retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/S HE
REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE
INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the ISOC's procedures with respect to rights in ISOC Documents can
be found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at ietf-
ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Baker & Nottingham Informational [Page 5]
^L
|
