1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
329
330
331
332
333
334
335
336
337
338
339
|
Internet Engineering Task Force (IETF) A. Begen
Request for Comments: 6128 Cisco
Updates: 5760 February 2011
Category: Standards Track
ISSN: 2070-1721
RTP Control Protocol (RTCP) Port for
Source-Specific Multicast (SSM) Sessions
Abstract
The Session Description Protocol (SDP) has an attribute that allows
RTP applications to specify an address and a port associated with the
RTP Control Protocol (RTCP) traffic. In RTP-based source-specific
multicast (SSM) sessions, the same attribute is used to designate the
address and the RTCP port of the Feedback Target in the SDP
description. However, the RTCP port associated with the SSM session
itself cannot be specified by the same attribute to avoid ambiguity,
and thus, is required to be derived from the "m=" line of the media
description. Deriving the RTCP port from the "m=" line imposes an
unnecessary restriction. This document removes this restriction by
introducing a new SDP attribute.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Further information on
Internet Standards is available in Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc6128.
Begen Standards Track [Page 1]
^L
RFC 6128 RTCP Port for Multicast Sessions February 2011
Copyright Notice
Copyright (c) 2011 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Table of Contents
1. Introduction ....................................................2
2. The 'multicast-rtcp' Attribute ..................................3
3. SDP Example .....................................................3
4. Security Considerations .........................................4
5. IANA Considerations .............................................4
5.1. Registration of SDP Attributes .............................5
6. Acknowledgments .................................................5
7. References ......................................................5
7.1. Normative References .......................................5
7.2. Informative References .....................................5
1. Introduction
The Session Description Protocol (SDP) [RFC4566] has an attribute
that allows RTP applications [RFC3550] to specify an address and a
port associated with the RTP Control Protocol (RTCP) traffic
[RFC3605]. This attribute is called 'rtcp'.
Now consider a network where one or more media senders send RTP
packets to a distribution source, which then multicasts these RTP
packets to multicast receivers using a source-specific multicast
(SSM) arrangement [RFC5760]. The distribution source also multicasts
the forward RTCP traffic (i.e., RTCP sender reports and receiver
reports or their summaries) to the receivers in the same SSM session.
In RTP-based SSM sessions, the 'rtcp' attribute is used to designate
the address and the RTCP port of the Feedback Target in the SDP
description [RFC5760]. However, the RTCP port associated with the
SSM session itself cannot be specified by the same attribute since it
could potentially cause ambiguity. Thus, the multicast RTCP port is
required to be derived from the "m=" line of the media description
Begen Standards Track [Page 2]
^L
RFC 6128 RTCP Port for Multicast Sessions February 2011
(see Section 10.2 of [RFC5760]) by following the +1 rule (see Section
11 of [RFC3550]). However, [RFC3550] lifted the requirement for the
+1 rule since it imposed an unnecessary restriction on RTCP port
selection.
In this specification, we introduce a new SDP attribute to remove
this restriction. The new attribute allows the multicast sender to
use its desired port in the RTCP session. This document updates
[RFC5760].
2. The 'multicast-rtcp' Attribute
In RTP-based SSM sessions, the distribution source can use different
multicast RTP and RTCP ports to send the RTP and RTCP packets,
respectively. Alternatively, the distribution source can use RTP/
RTCP port muxing [RFC5761], in which case the RTP and RTCP packets
are sent to the same destination port in the SSM session.
For the cases when the distribution source does not want to use the
one higher port for the RTCP traffic, this document defines a new SDP
attribute, called 'multicast-rtcp'. By using this attribute, the
distribution source uses a desired port for the SSM RTCP session. In
the absence of the 'multicast-rtcp' attribute, the +1 rule applies
following [RFC5760].
The following ABNF [RFC5234] syntax formally describes the
'multicast-rtcp' attribute:
rtcp-attribute = "a=multicast-rtcp:" port CRLF
Figure 1: ABNF syntax for the 'multicast-rtcp' attribute
Here, the 'port' token is defined as specified in Section 9 of
[RFC4566].
The 'multicast-rtcp' attribute is defined as both a media-level and
session-level attribute. Except where stated otherwise in this
document, the rules of [RFC3550] apply.
3. SDP Example
In the session description shown in Figure 2, a source stream is
multicast from a distribution source (with a source IP address of
198.51.100.1) to the multicast destination address of 233.252.0.2 and
port 41000. The forward RTCP traffic is multicast in the same
multicast group but to port 42000 as specified by the "a=multicast-
rtcp:42000" line. A feedback target with an address of 192.0.2.1 and
port of 43000 is specified by the 'rtcp' attribute.
Begen Standards Track [Page 3]
^L
RFC 6128 RTCP Port for Multicast Sessions February 2011
v=0
o=ali 1122334455 1122334466 IN IP4 ssm.example.com
s='multicast-rtcp' Example
t=0 0
a=rtcp-unicast:rsi
m=video 41000 RTP/AVPF 98
i=Multicast Stream
c=IN IP4 233.252.0.2/255
a=source-filter:incl IN IP4 233.252.0.2 198.51.100.1
a=rtpmap:98 MP2T/90000
a=multicast-rtcp:42000
a=rtcp:43000 IN IP4 192.0.2.1
a=mid:1
Figure 2: Example SDP showing the use of the 'multicast-rtcp'
attribute
4. Security Considerations
The 'multicast-rtcp' attribute is not believed to introduce any
significant security risk to multimedia applications. A malevolent
third party could use this attribute to redirect the RTCP traffic,
but this requires intercepting and rewriting the packets carrying the
SDP description; and if an interceptor can do that, many more attacks
are possible, including a wholesale change of the addresses and port
numbers at which the media will be sent.
In order to avoid attacks of this sort, the SDP description needs to
be integrity protected and provided with source authentication. This
can, for example, be achieved on an end-to-end basis using S/MIME
[RFC5652] [RFC5751] when SDP is used in a signaling packet using MIME
types (application/sdp). Alternatively, HTTPS [RFC2818] or the
authentication method in the Session Announcement Protocol (SAP)
[RFC2974] could be used as well.
5. IANA Considerations
The following contact information shall be used for all registrations
in this document:
Ali Begen
abegen@cisco.com
Begen Standards Track [Page 4]
^L
RFC 6128 RTCP Port for Multicast Sessions February 2011
5.1. Registration of SDP Attributes
This document registers a new attribute name in SDP.
SDP Attribute ("att-field"):
Attribute name: multicast-rtcp
Long form: Port in the multicast RTCP session
Type of name: att-field
Type of attribute: Media or session level
Subject to charset: No
Purpose: Specifies the port for the SSM RTCP session
Reference: [RFC6128]
Values: See [RFC6128]
6. Acknowledgments
Thanks to Colin Perkins and Magnus Westerlund for suggesting the name
for the 'multicast-rtcp' attribute and providing text for portions of
this specification. Some parts of this specification are based on
[RFC3605] and [RFC5760]. So, also thanks to those who contributed to
those specifications.
7. References
7.1. Normative References
[RFC3550] Schulzrinne, H., Casner, S., Frederick, R., and V.
Jacobson, "RTP: A Transport Protocol for Real-Time
Applications", STD 64, RFC 3550, July 2003.
[RFC4566] Handley, M., Jacobson, V., and C. Perkins, "SDP: Session
Description Protocol", RFC 4566, July 2006.
[RFC5760] Ott, J., Chesterfield, J., and E. Schooler, "RTP Control
Protocol (RTCP) Extensions for Single-Source Multicast
Sessions with Unicast Feedback", RFC 5760, February 2010.
[RFC5234] Crocker, D. and P. Overell, "Augmented BNF for Syntax
Specifications: ABNF", STD 68, RFC 5234, January 2008.
7.2. Informative References
[RFC3605] Huitema, C., "Real Time Control Protocol (RTCP) attribute
in Session Description Protocol (SDP)", RFC 3605,
October 2003.
[RFC5761] Perkins, C. and M. Westerlund, "Multiplexing RTP Data and
Control Packets on a Single Port", RFC 5761, April 2010.
Begen Standards Track [Page 5]
^L
RFC 6128 RTCP Port for Multicast Sessions February 2011
[RFC5652] Housley, R., "Cryptographic Message Syntax (CMS)", STD 70,
RFC 5652, September 2009.
[RFC2818] Rescorla, E., "HTTP Over TLS", RFC 2818, May 2000.
[RFC2974] Handley, M., Perkins, C., and E. Whelan, "Session
Announcement Protocol", RFC 2974, October 2000.
[RFC5751] Ramsdell, B. and S. Turner, "Secure/Multipurpose Internet
Mail Extensions (S/MIME) Version 3.2 Message
Specification", RFC 5751, January 2010.
Author's Address
Ali Begen
Cisco
181 Bay Street
Toronto, ON M5J 2T3
Canada
EMail: abegen@cisco.com
Begen Standards Track [Page 6]
^L
|
