1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
|
Internet Engineering Task Force (IETF) T. Narten
Request for Comments: 6355 J. Johnson
Category: Standards Track IBM
ISSN: 2070-1721 August 2011
Definition of the UUID-Based DHCPv6 Unique Identifier (DUID-UUID)
Abstract
This document defines a new DHCPv6 Unique Identifier (DUID) type
called DUID-UUID. DUID-UUIDs are derived from the already-
standardized Universally Unique IDentifier (UUID) format. DUID-UUID
makes it possible for devices to use UUIDs to identify themselves to
DHC servers and vice versa. UUIDs are globally unique and readily
available on many systems, making them convenient identifiers to
leverage within DHCP.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Further information on
Internet Standards is available in Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc6355.
Copyright Notice
Copyright (c) 2011 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Narten & Johnson Standards Track [Page 1]
^L
RFC 6355 DUID-UUID August 2011
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Background . . . . . . . . . . . . . . . . . . . . . . . . . . 2
3. UUID Considerations . . . . . . . . . . . . . . . . . . . . . . 3
4. DUID-UUID Format . . . . . . . . . . . . . . . . . . . . . . . 4
5. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 4
6. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 5
7. Security Considerations . . . . . . . . . . . . . . . . . . . . 5
8. References . . . . . . . . . . . . . . . . . . . . . . . . . . 5
8.1. Normative References . . . . . . . . . . . . . . . . . . . 5
8.2. Informative Reference . . . . . . . . . . . . . . . . . . . 5
1. Introduction
DHCP Unique Identifiers (DUIDs) are used in DHCPv6 to identify
clients and servers. This document defines a new DHCP Unique
Identifier (DUID) type that embeds a Universally Unique IDentifier
(UUID) [RFC4122]. UUIDs are already in widespread use and serve as
an existing identifier that could be leveraged by DHCPv6. For
example, x86-based systems ship with an embedded UUID in firmware
that is readily available to the software running on the device.
Although DUIDs are new to DHCPv6, identifying clients in DHCP via a
UUID is not. DHCPv4 [RFC2132] defines a Client Machine Identifier
Option (option 97) that embeds a UUID (aka a Globally Unique
Identifier (GUID)) [RFC4578]. This document extends that capability
to DHCPv6.
Terminology specific to IPv6 and DHCPv6 is used as defined in the
"Terminology" sections of [RFC3315].
2. Background
In DHCPv6, clients identify themselves to servers via DHCP Unique
Identifiers (DUIDs) [RFC3315]. DUIDs are identifiers that DHCP
servers treat as opaque objects with no internal structure. DUIDs
are intended to be globally unique, with no two devices using the
same DUID. Three DUIDs types have been defined previously:
DUID-LLT - the Link-Layer address of one of the device's network
interfaces, concatenated with a timestamp
DUID-EN - an Enterprise Number plus additional information specific
to the enterprise
DUID-LL - the Link-Layer address of one of the device's network
interfaces
Narten & Johnson Standards Track [Page 2]
^L
RFC 6355 DUID-UUID August 2011
DUIDs are intended to remain constant over time, so that they can be
used as permanent identifiers for a device. In the case of DUID-
LLTs, they are intended to be generated once, stored in stable
storage, and reused from that point forward.
One issue that has arisen concerns devices that employ multi-step
network boot loading. An initial step (typically run out of
firmware) loads a small image that, in turn, loads a second image and
so forth until the actual target system is loaded. Each step in the
booting process may invoke DHCP. In some operational environments,
it is important that each step in the sequence use the same DUID, so
that the server knows it is getting requests from the same device and
can return the proper configuration information (including the
pointer to the correct image to load).
Unfortunately, none of the previously defined DUIDs are ideal for
multi-step network booting. The DUID-LLT and DUID-LL identifiers
that a given device may use are not guaranteed to remain constant
across each booting step. Even if the different stages used DUID-LL
or DUID-LLT, on devices with multiple interfaces, there is no way to
guarantee that the same interface (and hence DUID) will be selected.
Finally, in the case of DUID-LLT, even if the same interface is
chosen, it can be difficult to ensure that each stage uses the same
timestamp value. While a DUID-EN could be defined and used, such
usage is proprietary by definition.
This document defines a new DUID type, based on the Universally
Unique IDentifier (UUID) [RFC4122]. UUIDs are already used in
practice and serve as an existing identifier that could be leveraged
by DHCP. In some environments, a UUID-based DUID is preferable to
the other existing DUID types.
It should be noted that use of a DUID-UUID will not, by itself, solve
all the network boot problems described in this document. Given the
availability of a suitable DUID-UUID, implementations will still need
to take steps to ensure that all boot stages use the same DUID-UUID
as appropriate. Given that DHCP has already defined multiple DUID
types, the question of which of several DUIDs to select from already
exists, and defining a new DUID type does not, by itself, help. It
is believed, however, that network boot services can be configured to
use a DUID-UUID and that other software can do so as well. Ensuring
this happens in general is beyond the scope of this document.
3. UUID Considerations
Although many UUIDs are in use today, not all UUIDs meet DHCP's
requirements (see Section 9 of [RFC3315]). DHCP UUIDs should be
persistent across system restarts, system reconfiguration events,
Narten & Johnson Standards Track [Page 3]
^L
RFC 6355 DUID-UUID August 2011
system software and operating system upgrades or reinstallation as
well as be easily available to any part of the boot process that
requires access to the DHCP UUID. For example, UUIDs used in
Microsoft's Component Object Module (COM), and for labeling
partitions in filesystems, are likely not appropriate as they may not
be accessible to firmware boot loaders and can change over time.
Implementations of this specification using DUID-UUID must select a
UUID that is persistent across system restart and reconfiguration
events and that is available to all DHCP protocol agents that may
need to identify themselves. For instance, a UUID that is part of
the system firmware, or managed by the system firmware, satisfies
this requirement.
4. DUID-UUID Format
The DUID-UUID is carried within Client Identifier or Server
Identifier options. It has the following format:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| DUID-Type (4) | UUID (128 bits) |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |
| |
| |
| -+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-
Figure 1: DUID-UUID Format
DUID-Type - DUID-UUID (4) - (16 bits)
UUID - An [RFC4122] UUID (128 bits)
5. Acknowledgements
This document was inspired by a discussion on the DHC mailing list in
November 2009 on the topic of netboot for IPv6. Specifically, some
scenarios were described where it was difficult to do something in
DHCPv6 that had worked well in DHCPv4.
We would like to thank the following individuals in particular for
their specific comments and suggestions on this document: Thomas
Huth, Andre Kostur, Stephen Jacob, Suresh Krishnan, Ted Lemon, Bernie
Volz, and Vincent Zimmer.
Narten & Johnson Standards Track [Page 4]
^L
RFC 6355 DUID-UUID August 2011
6. IANA Considerations
IANA has assigned the value 4 for use by the DHCPv6 DUID-UUID type.
7. Security Considerations
DHCP traffic between a client and server is sent in the clear. An
eavesdropper residing on the path between the client and server could
see DHCP traffic and obtain the UUID for a particular machine. This
may raise some privacy issues but is not a new issue brought on by
the use of the DUID type defined in this document.
8. References
8.1. Normative References
[RFC2132] Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor
Extensions", RFC 2132, March 1997.
[RFC3315] Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C.,
and M. Carney, "Dynamic Host Configuration Protocol for
IPv6 (DHCPv6)", RFC 3315, July 2003.
[RFC4122] Leach, P., Mealling, M., and R. Salz, "A Universally
Unique IDentifier (UUID) URN Namespace", RFC 4122,
July 2005.
8.2. Informative Reference
[RFC4578] Johnston, M. and S. Venaas, "Dynamic Host Configuration
Protocol (DHCP) Options for the Intel Preboot eXecution
Environment (PXE)", RFC 4578, November 2006.
Authors' Addresses
Thomas Narten
IBM
EMail: narten@us.ibm.com
Jarrod B. Johnson
IBM
EMail: jarrod.b.johnson@gmail.com
Narten & Johnson Standards Track [Page 5]
^L
|
